Shoprider streamer power chair manual

Next Page. Shoprider user manual power wheelchair iso, iso, iso 29 pages. Page 3: Introduction Powerchair. Please read it carefully before using the Powerchair and make sure you understand all the instructions. Please make sure that you are physically fit to operate this unit. Swing-Away Joystick Mount Bracket Remark: For other available accessories if required, please consult your authorized provider. The more mobility your Powerchair brings, the happier you will be!

But, with all things, observing a few rules will ensure safe maneuvering. So please… 1 Do not drive the Powerchair without reading this instruction manual. For more information regarding the programming parameters for the programmable Powerchair controller please contact your provider. Under the armrest, there is a bolt and lock nut 1 that can be adjusted up or down to change the angle of the armrest. Place the armrest assembly on the desired side. Reset in position by re-tightening the hand knobs to complete joystick conversion.

Do not use this button to stop the Powerchair, except in an emergency. Speed Decrease Button 2 This button decreases the maximum speed. The Battery Gauge is a guide on the remaining charge in the batteries. The Battery Gauge is used to indicate power on and provides an estimate of the remaining battery capacity. Any green LEDs lit indicate well charged batteries. If only amber and red LEDs are lit, the batteries are moderately charged. Recharge before undertaking a long trip.

If only red LEDs are lit, the batteries are running out of charge. Recharge as soon as possible Batteries should be kept fully charged at all times. They must not be left in a discharged state if not using the unit for some time.

The batteries should be checked once a month and recharged as needed. Always wear eye protection when working near batteries.

Check the power module for a fault, the cable for damage, and that the battery is sufficiently charged. Read the battery charger instructions in this manual and in the manual supplied with the charger prior to charging the batteries.

Do not remove the grounding prong from the plug. Removal of the grounding prong could result in an electrical hazard. Only plug the charger into a 3-pronged electrical outlet, or an approved 3-pronged adapter for use with a 2 pronged electrical outlet. Make sure that the wall outlet being used is not controlled by a wall switch that can be easily turned off. Do not use an extension cord to plug in the charger.

Do not leave the charger plugged into the charger port if the charger is not charging the unit. Use only the off-board charger supplied with this unit. Never use an automotive type battery charger. Contact your supplier if a replacement off-board charger is needed. Inspect the battery charger, wiring and connections for damage prior to each use.

Do not open the battery charger case. The battery charger is supplied with cooling slots. Do not insert objects through the slots. Make sure that the charger is not in contact with inflammable materials at any time. The off-board charger is for indoor use only. Explosive gases may be generated while charging the batteries. Keep the power chair and battery charger away from sources of ignition such as flames or sparks and provide adequate ventilation when charging the batteries.

Do not allow children to play near the power chair while the batteries are charging. It is also recommended that the batteries not be charged while the power chair is occupied.

Plug the charger into the wall outlet. The charging process will start automatically. Make sure to use two batteries of the exact same chemistry, amp hours, and capacity. Fully recharge new batteries prior to initial use. It is recommended that the batteries be charged for 8 to 14 hours after daily use. If the power chair is used infrequently Once a week or less the batteries will need to be charged once a week for 12 to 14 hours.

Do not charge the batteries for more than 24 hours at a charging cycle. Batteries that go below a minimum voltage due to not being charged will be unable to be re-charged. If you do not plan on using your power chair for an extended period it is recommended that you fully charge the batteries and then disconnect the battery harness prior to storage.

Store the power chair in a warm dry environment. Never store the batteries where extreme temperatures are possible. Never attempt to charge a frozen battery. A cold or frozen battery should be warmed for several days prior to charging. Without the use of any servicing tools, the condition can be simply diagnosed. If after checking out the fault from the table below and the fault is still showing, do not use the Powerchair.

Turn off the power and consult your provider immediately. Release the joystick to neutral and try again. Try charging the batteries. Batteries may require replacing. Replace the Remote. Replace the Power Module. Check for worn motor brushes. Consult a service agent. The locking method is achieved through a sequence of key presses and joystick movements, as detailed below. Sleep mode will not be entered while programming. Structural Frame — 3 Years Shoprider Australia warrants that the frame will be free from defects under normal use, for a period of three 3 years from the date of purchase by the original customer.

Shoprider Australia will repair or replace, at our option free of charge any part found on examination by Shoprider Australia to be defective in material and or workmanship within the warranty period.

All parts claimed under warrant must be returned to Shoprider Australia in their present condition. Structural Frame Components include Welded Chassis only Drive Train Assembly — 18 months Shoprider Australia warrants that the drive train Assembly will be free from defects under normal use, for a period of eighteen 18 months from the date of purchase by the original customer.

Exclusions 1. The Streamer Sport has a mile battery range and 2in. The Jimmie is a portable and light weight power chair designed for the consumer on the go. The unit has a quick-disconnect system for effortless disassembly, advanced electronics and high efficiency in-line motors. The Jimmie disassembles effortlessly into three pieces, with the heaviest weighing just Shoprider introduces another first in powered mobility with its extremely lightweight, high performance, extended life high energy batteries.

The Smartie also features our flip back height adjustable armrest, flip-up footplate and easy access battery compartment. Power Chairs. XLR XLR Plus.